Sorry, In Flexi it is inches so it is close to 0. move at either -.05mm increments or +.05mm until you get sharp corners on your test cuts. Put the blade offset at 0.25mm and make test cuts using the test feature on your vinyl cutter. keep adjusting the force until it cuts smoothly. Keep adjusting the blade in until it just barely makes any mark on the vinyl backing, Now put the holder back in your vinyl cutter. There should just barely be a marking on the vinyl backing. It sounds like your blade is out too far., try this.Īctually you can take the blade holder out of the vinyl cutter, and in your hand cut across a piece of vinyl. I am still learning all the time.Trying to learn speeds and pressure right now and why it sometimes pulls pieces off as it cuts. I bought the software as suggested and things have been smooth sailing. The USCutter MH Series comes equipped with the VinylMaster Cut (Basic Edition) software. That’s a lot of craft cutting for a machine at such a low price point It works at 39 in/s speed at a force of 350 grams. I have the system up and running, and have been doing alot of cool stuff with my "Cutter" (Not Printer even though I wanted to say it Skeeter ) The 34in can cut a maximum width of 30.63 inches and a maximum length of 8 feet. Sorry it has been awhile since I revisited this post.Have been busy as all get out, and ill at the same time.īut I did want to revisit and say THANKS! To everyone especially Skeeter for the help in getting me up and running.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |